RSPCA Shop

Make Your Own Wooden Football Game: Step-by-Step Guide

Make Your Own Wooden Football Game: Step-by-Step Guide

By RSPCA Shop | Published: 2026-10-24

Category: How-to Guides

Build your own wooden football table with this easy DIY kit. No glue needed—just pop out the pieces and follow these simple steps for a fun family craft.

Quick Answer

Assemble your own wooden football table in about 30 minutes using the Make Your Own Wooden Football Game kit—no glue or tools required, just pop out the pieces and follow the order below.

Why This Kit Works Well for Beginners

The kit includes 46 wooden pieces spread across four boards, plus a small ball and easy-to-follow instruction sheets. Because the parts are made from plywood and fit together without glue, you can correct mistakes easily and even disassemble the game for storage or travel.

The finished table measures 25 cm × 18 cm × 5 cm, making it compact enough for a desk or coffee table but still large enough for two players to enjoy a quick match.

Assembly Steps

  1. 1. Pop Out All Pieces: Carefully press each wooden piece out of its board. Start with the largest pieces (the side panels and goal frames) and work down to the small rods and players. Keep the instruction sheet nearby to identify each part. Common mistake: forcing a piece that is still attached. If a piece resists, wiggle it gently rather than bending the board.
  2. 2. Build the Goal Frames: Fit the two goal frames together by sliding the tabs into the corresponding slots. Each frame should feel snug but not tight. Set them aside. Checkpoint: the goals must sit flat on the table. If they wobble, recheck the tab alignment.
  3. 3. Attach the Side Panels: Insert the side panels into the slots on the base board. The panels should stand upright and parallel to each other. The goal frames will later slide between them. Common mistake: mixing up left and right panels. The instruction sheet shows which side has the player rod holes.
  4. 4. Insert the Playing Rods: Slide the long rods through the holes in the side panels. Each rod has a pre-attached player figure. Push the rod until the figure is centered on the playing field, then add the small stopper piece on the outer end. Checkpoint: rotate each rod to ensure the player figure swings freely without hitting the side panels.
  5. 5. Add the Goals and Top Bar: Place the assembled goal frames between the side panels at each end. Then snap the top bar across the side panels to lock everything in place. The top bar should click into the notches on both sides. Common mistake: forcing the top bar. If it doesn't click, check that the side panels are fully seated in the base.
  6. 6. Place the Ball and Play: Drop the wooden ball into the center of the field through the gap in the top bar. Each player controls two rods to flick the ball toward the opponent's goal. The first to score five goals wins. Checkpoint: if the ball gets stuck under a player figure, gently lift the rod and reposition the ball.

What's in the Kit

  • Make Your Own Wooden Football Game: The kit contains 46 wooden component pieces across four boards, including a ball, and easy-to-follow instruction sheets. Material is plywood. No glue or extra tools are needed, so children can assemble it safely with minimal adult supervision.
    Make Your Own Wooden Football Game
    Make Your Own Wooden Football Game

Shop Related Products

Make Your Own Wooden Football Game

Make Your Own Wooden Football Game

$8.06 $13.00

Shop Now